HP 940 HP 88 Printhead Repair Cleaning kit
This suction clip works for HP 940 and HP 88 Unclogging Cleaning Print Heads.
- 2 Suction Clip ( Yellow clip: Magenta & Cyan , Black clip: Black & Yellow)
- 4 Ink Hose
- 1 Syringe for suction clip
- Detailed Instructions
How to unclog your HP 940 and HP 88 Print Head
1. pull up after clip installed on desired clog color, if it won’t able to pull, the you head clogged.
2. Put some warm water(not hot water, it will burn your nozzle ) , in syringe and put it the hole and push it down slowly until water goes in to the printhead, if syringe has too much tension then stop , leave it for 10 to 15 min. to get best result , use printhead ceaning liquid
3. After 15 min, pull syringe back, then you may hear little air suction noise, if syringe able to pull up and suction out old ink, then its unclogged. Sometime if you had that printhead clogged for long time then it may not able to unclog. Then you have to disassemble the printhead to rinse out all sludge’s in the printhead. To remove sludge ; type hp 940 printhead cleaning on youtube, you may find some information. If you feel like its unclogged but not enough, then do it again.
4. After unlogged printhead, then fill up the ink
To get all best result use right tools and material. If you think you can not fix it, then do not attempt to do it, just send it over to me.
Contact to me before you send, I will send you shipping information & packing guide.
It will takes couple day to fix it, but it is not guaranteed !, it may not able to repair if it has film damaged, nozzle burned, any chip damaged.